Triple Duty Valve Manufacturer in India

 

Specialityvalve is the topmost Triple Duty Valve Manufacturer in India. The triple duty valve performs all the functions normally that are required on the discharge side of the hydronic pump systems. The valve serves as an anti-slam check valve as needed for pumping as parallel. It has a calibrated nameplate for rough system balance. The calibrated nameplate allows the valve to return to the original balance position after shutoff.

When it comes to the installation the valve must not be mounted directly to the pump. This is to prevent system noise and damage to the check valve components, especially the clapper. Placing it directly on the pump discharge places it at a point of extreme flow and pressure changes and high turbulence. It may be installed in either a vertical or horizontal orientation, the stem must be pointing upward. If used as a balance device the valve should be installed with a 10x pipe diameter between the triple duty valve and pump discharge.

Specialityvalve is one of the best Triple Duty Valve Manufacturer in India which has specification designed to perform the functions of an anti-slam check valve, throttling valve, shutoff valve, and calibration balancing valve.

Advantages of triple duty valve:

• Soft seated disc ensures a leak-tight seal
• Outside screw and yoke operation
• Hand wheel to throttle the valve
• By-pass valve for fine balancing of pressures

  Industries that use Triple Duty valves:

·      Chemical industry

·      Oil and Gas Industry

·      Marine Industry

·      Petroleum Industry

 

Available materials: Cast iron, SS304, SS316, CF8, CF8M, Ductile iron

Size: 2” to 20”

Class: 125 to 300

Nominal Pressure: PN6 to PN25

Ends: Flanged

https://www.specialityvalve.com/product-category/triple-duty-valve/